2. Function Design Procedure

1. Specification
   We will consider if the specification similar to or an extension on an existing product. If this is the case the project is likely to go straight to EVT or DVT, unless otherwise specified.  If the project is not similar to an existing product an original design request will be raised to identify the most appropriate technology.
2. Bread Board or Assembly Test
   Converting a circuit diagram to a PCB layout is not straightforward because the arrangement of components on the board will look different from the circuit diagram. A breadboard is used to make up temporary circuits for testing and assembly tests.
3. New Components?
   If not specified by customer decided by R&D then, if required, submitted for approval
4. Prototype Assembly
5. Function Specification Check
6. Design Review
7. EVT or DVT1
8. EVT:
9. Issue BOM and Sample
10. Sample Evaluation
11. Design Review
12. Function Improvement
13. DVT1 or DVT2
14. DVT1:
15. Issue BOM and Sample
16. Sample Evaluation
17. Customers Test Data
18. Design Review
19. DVT2/MVT
20. Environmental Analysis

Last Amendment: 03/04/2007 10:58:11