| AC Input Voltage |
90~264 Vac, 47~440Hz / 127~370Vdc |
| AC Input Current |
2.9A at 115Vac, 60Hz or 1.7A at 230Vac, 60Hz with 100% output load |
| Inrush Current |
<22A at 115Vac or 45A at 230Vac, cold start |
| Set Up, Rise Time |
800ms, 20ms / 230Vac 2000ms, 50ms / 115Vac, full load |
| Hold-Up Time |
80ms / 230Vac 14ms / 115Vac, full load |
| Leakage Current |
<180µA at 264Vac |
| DC Output Adj. Range |
-5% to +10% rated output |
| Over Load Protection |
120 ~ 160% rated load, auto recovery |
| Over Voltage Protection |
115 ~ 135% rated output |
|
120% ~ 140% rated output on 15, 24 & 48V |
| Power Good/Fail Signal (Optional) |
At 90% of rated value, a+5V TTL signal will be sent out with a 10~500ms delay; |
|
at least 1ms before the output voltage goes below 90% of the rated value,the TTL signal will be |
|
turned off. *MPS-120-3.3 does not have this optional function. |
| Working Temperature |
-20°C to +70°C. Refer to derating curve |
| Working Humidity |
20 ~ 90% RH non-condensing |
| Storage Temperature, Humidity |
-40°C to +85°C, 10~90% RH |
| Temp. Coefficient |
±0.04%/°C on all outputs at full load between 0~50°C of ambient temperature. |
| Vibration |
2G of acceleration, vibrating frequency adjust from 10Hz ~500Hz within a 10 min cycle |
| Safety Standards |
Medical: UL60601-1, TUV EN60601-1 approved |
|
Commercial: Also design refer to UL60950-1, TUV EN60950-1 |
| Withstand Voltage |
I/P-O/P:4000VAC, I/P-FG:1500VAC, O/P-FG:500VAC between |
| Isolation Resistance |
>100M Ohms for I/P-O/P, I/P-FG, O/P-FG by using 500VDC test voltage |
| EMI Compliance |
Compliance to EN55011 Class B, EN55022 Class B, EN61000-3-2, EN61000-3-3 |
| EMS Compliance |
Compliance to EN61000-4-2, EN61000-4-3 |
|
EN61000-4-4 Level 2, 1KV/5KHz,Level 3, 2KV/5KHz |
|
EN61000-4-5,Level 4, 2KV/Line-Line 4KV/Line-Earth,EN61000-4-6 Level 2, 3Vrms/m,Level 3, 10Vrms/m |
|
EN61000-4-8,Level 2, 3A/m,Level 3, 10A/m,EN61000-4-11 Compliance |
|
ENV50204,Level 2, 3V/m, 900MHz,Level 3, 10A/m, 900MHz |
| MTBF |
262,100 hours min, 25°C |
.jpg)
