Features- AC input 180~260VAC, 3Ø 3 wire
- AC 220V, 1Ø or 380V, 3 Ø4 wire(option)
- PFC 0.98@ 230VAC
- Protections: Short circuit, overload, over voltage, over temperature
- Built-in remote sense function, remote ON-OFF control
- Power good signal
- With parallel function(N+1)
- Can adjust from 25~100% output voltage by external control 1-5V
|
Standards
     
|
Specification
| VOLTAGE ADJ. RANGE |
?5.0% Typical adjustment by potentiometer 25%~100% adjustment by 1~5VDC external control |
| SETUP, RISE, HOLD TIME |
500ms, 50ms, 16ms at full load |
| VOLTAGE RANGE |
180 ~ 260VAC 3? 3 wire (other system available) 90~180VAC see the derating curve |
| FREQUENCY RANGE |
47~63Hz |
| POWER FACTOR |
>0.98/230VAC |
| AC CURRENT |
13.5A/230VAC @1? |
| INRUSH CURRENT (max.) |
COLD START<60A/230VAC |
| LEAKAGE CURRENT |
<3.5mA / 240VAC |
| OVER LOAD |
<5s Current limiting , Reset: auto recovery |
|
>5s Shutdown, Reset: re-power on |
| OVER VOLTAGE |
110 ~ 135% Follow to output set up point |
|
Shut down o/p voltage, re-power on to recover |
| OVER TEMPERATURE |
100?C/ measure by heat sink, near transformer |
| WORKING TEMP., HUMIDITY |
-10 ~ +50?C @100% LOAD, +65?C @ 50 LOAD, 20 ~ 90% RH non-condensing |
| STORAGE TEMP., HUMIDITY |
-20~+85?C , 10~95% RH |
| TEMP. COEFFICIENT |
?0.04%/?C (0~50?C) |
| VIBRATION |
10~200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes |
| SAFETY STANDARDS |
UL60950, TUV EN60950 Approved |
| EMI CONDUCTION & RADIATION |
Compliance to EN55022 (CISPR22) Class A |
| HARMONIC CURRENT |
Compliance to EN61000-3-2,-3, Class D |
| EMS IMMUNITY |
Compliance to EN61000-4-2,3,4,5,6,8,11, Light industry level, criteria A |
| WITHSTAND VOLTAGE |
I/P-O/P:3KVAC I/P-FG:1.5KVAC for 1min. |
| ISOLATION RESISTANCE |
I/P-O/P, I/P-FG:100M Ohms/500VDC |
| POWER GOOD SIGNAL |
Open collector of NPN transistor |
| SPECIAL FUNCTION |
DC Voltage Adj., Remote sensing, remote control, parallel operation(refer to terminal instruction ma |
|
.jpg)
